Yamaha FZ750 Restoration - Burleigh Powder Coating.

The Frame is Back!

True to their word, less than a fortnight later and I got the call that it was ready to pick up. I was slightly apprehensive due to the fact that the rust was pretty bad, with heavy pitting. When you don't get to see what's left after blasting, it's always a worry. It's not cheap either. 

Would I have been better off with a wire brush in a drill and using aerosols? 😟 That would have taken forever as it's a big, complex frame. And the results are never the same when spraying a frame, overspray always dulling one side etc.

The powder coating on the BSA frame is still superb after thirty years, so I'd pretty much made my choice.

First, a wee recap. She was looking a little worse for wear...

The photos actually make it look far better than it was. Brake fluid had taken paint off in some places, rust had started taking over everywhere else. The centre stand looked like it had been dragged up from the Titanic.

The Yamaha FZ750 Restoration.

Blown away...

Carlsberg don't do projects, but if they did, they'd probably be the best projects in the world. Quite frankly, if a restoration project could be ideal, this one could well be it. Admittedly, the plastics are a bit rough, but mechanically she's proving to be pretty good.

After getting the engine running, the bike was quickly stripped and put into boxes. From here I will take pics, and start on individual components. If I get a bit fed up with doing one thing for too long, I'll move on to something else to break up the monotony. It's easy to get overwhelmed when stuck on a time-consuming part.

Anyone who has pulled old machines apart would be familiar with stripped heads on screws and bolts, especially when some of the bike is as rusty as this one. But, as corroded as every fastener is, everything came apart like it was put together last week! It's been surreal.

I had noticed play in the front wheel during the strip-down and was pretty shocked to find this.