Showing posts with label GS series. Show all posts
Showing posts with label GS series. Show all posts

Thursday, March 11, 2021

Suzuki GS Series — Clutch End Float.

Low speed rattles?

There's a few common places that annoying rattles can resonate from on ye olde GS. One of them being the clutch.

It's a heavy unit to be spinning around on the big needle roller bearing and you will always see and feel the [normal] movement when you get hold of the clutch basket. Considering that the huge helical gear around the outside of it is being driven by the crank itself, movement isn't what you want. That sort of freeplay doesn't really matter, for instance, if the clutch is being driven by chain or belt as there is more flex. Gears don't exactly flex, but they will wear. 

On top of this, there is a gear sat behind it, driven by the basket, which then drives the oil pump. A lot going on for something that only has one bearing. 

Now a couple of the intelligent folks at GSResources forum removed some of the play by machining a little off the bearing hub that runs on the inside of the needle roller bearing. In effect, this removes a little of the end float and holds the basket at the angle it was designed to run. Thereby keeping the gears at the correct angle, and reducing some of the noise inside. Sounds good huh?


That's the back of the clutch basket. The large gear is driven by the crankshaft. The two slots in the back of the clutch centre drive the gear that, in turn, drives the oil pump. The springs you can see are for cushioning take up of drive as you let the clutch out to pull away etc. These sag slightly with age and, ideally, need replacing because they start to rattle. Or, as I was about to do, you can shim them with washers to quieten them down.

So this unit has a few jobs to do. Probably best that it spins as it should instead of flopping under its own weight...