Suzuki GS Series — Starter Clutch Rattles

The final check?

As anyone who has followed this blog will know, the engine out of the GS550E has been stripped completely. And, obviously, this was the ideal time to do a simple check on the starter clutch. And I full intended to, had I had the correct flywheel puller. A simple M14 x 1.5mm bolt is all it needs...

But no!

I'd already bought a pretty extensive universal puller/slide hammer with all sorts of adaptors, but none of them being a basic M14 x 1.5mm bolt. Anyway, I ignored it, and refitted the crank with flywheel still attached, not realising what could happen behind the flywheel.

And there it is, flywheel/rotor with starter clutch and gear bolted up behind it.

Suzuki GS Series — Clutch End Float.

Low speed rattles?

There's a few common places that annoying rattles can resonate from on ye olde GS. One of them being the clutch.

It's a heavy unit to be spinning around on the big needle roller bearing and you will always see and feel the [normal] movement when you get hold of the clutch basket. Considering that the huge helical gear around the outside of it is being driven by the crank itself, movement isn't what you want. That sort of freeplay doesn't really matter, for instance, if the clutch is being driven by chain or belt as there is more flex. Gears don't exactly flex, but they will wear. 

On top of this, there is a gear sat behind it, driven by the basket, which then drives the oil pump. A lot going on for something that only has one bearing. 

Now a couple of the intelligent folks at GSResources forum removed some of the play by machining a little off the bearing hub that runs on the inside of the needle roller bearing. In effect, this removes a little of the end float and holds the basket at the angle it was designed to run. Thereby keeping the gears at the correct angle, and reducing some of the noise inside. Sounds good huh?

That's the back of the clutch basket. The large gear is driven by the crankshaft. The two slots in the back of the clutch centre drive the gear that, in turn, drives the oil pump. The springs you can see are for cushioning take up of drive as you let the clutch out to pull away etc. These sag slightly with age and, ideally, need replacing because they start to rattle. Or, as I was about to do, you can shim them with washers to quieten them down.

So this unit has a few jobs to do. Probably best that it spins as it should instead of flopping under its own weight...

Suzuki GS550E — Steering head bearings.

Wandering Aimlessly...

Since the new Metzelers have been fitted, there has been a slight weave at low speed. I hope it's a steering bearing issue and not a trait of the new boots. Being as it was on the list of to-do's for along time, I ordered a genuine top bearing from Suzuki, as there doesn't seem to be an equivalent generic part number, and the old "32006" taper roller from the local bearing shop for the bottom yoke.

While it was apart, it would be time to clean up and paint various parts on the front end. A month and half later and I'm still waiting on the springs to come from America. Postal service is struggling as they're waiting for flights!

Anyway, back to the clean up. The main things on the list were the yokes/triple clamps, headlamp brackets, indicator brackets, and maybe the speedo surround and headlamp itself.