You can put the insulation tape away too!
It maybe considered pedantic, considering the rest of the bike at the moment, but I didn't like the white, heat resistant (?) sheathing on the wiring from the signal generator. It was torn in places, fraying and looked scruffy - not really the look I was going for (for the wiring at least).
So, with a little bit of looking around on the dock of the eBay, I found some Techflex. A plastic braided sleeve which expands when you push it together so that you can get it over various looms, hoses or cables etc. When it goes back to its original length, it tightens back up and looks great. Worth a shot of anyone's money I thought.
Here's the old covering looking a bit dilapidated. I'd cleaned it up as best I could, but some things have their limits.
Misfire in the Wet? Weak Spark?
Sat under the tank, they tend to get forgotten. But the leads that take the all important spark to the plugs need to be fully-insulated. If moisture gets in where the coil makes contact with the copper-cored plug lead, your 40,000 volts will probably make its way down the side to earth, rather than putting a spark across your plug electrodes. Why? Because it's lazy and wants the easy path. Wouldn't we all?
If you've ever touched a distributor cap, or lead, on an engine with a misfire, you might have felt the same sort of kick. It's easier to find a path to earth through you, than fire a spark across two metal points that are 0.75mm or more apart, especially in a cylinder containing high pressure air/fuel mixture.
The same can be said for the other end where your plug caps are. The rubber sealing boots are falling apart on the GSX's caps, so I'm putting new NGK's on it. For the price of them, it's not worth taking chances.
So what's that got to do with the price of fish?
Well, the original retaining clips for the plug leads had long since made for the hills. When the bike came to me the HT leads were hanging in by the fact that they were completely rigid and couldn't move, and a bit of good luck thrown in. Don't get me wrong, the bike ran fine, but it would have been different in rain.
Later coils did away with the clips altogether, and came factory sealed with a resin of some sort. As much as I would like them to go back together as Mr Denso wanted, without new clips, I'm going to have to seal them in semi-permanently too.
New parts are rolling in fast.
But some of the old bits seem to have done a bunk! I cleaned, painted (then scratched) a LH handlebar switch last week. Convinced it wasn't the one off this bike, and that it came in a box of Katana bits, I did it anyway. Why didn't I think it was off this GSX? The choke lever is snapped off on the Katana one.
I just went through all the pics I took of the bike and, sure enough, the choke lever is intact on the original switch - but where the f#*k is it?
I had a massive clear-out and general tidy in the garage this weekend and went through all the boxes. The switch and clutch lever have definitely gone AWOL. Oh well, hopefully they'll turn up soon.
In the meantime, new acquisitions have been turning up while I had some spare cash. Needing new master cylinder reservoirs, I went looking on good old eBay. A nice, anodised black, aluminium cylindrical reservoir was found for the princely sum of $7.55 delivered. How could you possibly go wrong?
Is it salvageable?
More to the point, would you want to?
The elements have infiltrated every visible component and it looks ready for the bin, but these are my favourite type of projects. Too simple to just throw it away, so can life be breathed through this part once more? I'll give it a whirl.
Time for WD40, heat, hot water - might even break the hammer out!
