Metzeler Tyre Test — Suzuki GS550E

First, a bit of history... hey, life isn't all just fun you know!

When the old GS came to me, that fateful morning in 2012, I knew it was going to change my life. It sat there for a long time, mournfully looking to be put back out there, to race around on the mountain roads, to show what it was really capable of.

But I had a GSXR1000 and a DRZ400 supermoto for the fun stuff. This one would wait. However, it kept looking... and I kept ignoring. 

Until, one day, it was reassembled enough to run under its own steam. The excitement was building. The little GS felt proud, there was potential and we could both see it. She was ready to go out and try the roads for the first time in years. The front tyre, however, was looking a bit lame. So I bought a secondhand Dunlop on eBay that was originally fitted to a Harley, the little GS wasn't happy about that, but it meant we got to ride. The rear Barracuda (the what?) had plenty of tread left so she was good to go. And for years she rode around on those old tyres, the front now being seventeen years old 😱.

GS673 Conversion — Cleaning The Crankcases and Painting Engine.

The 673 kit.

The next step for the GS550 is to relieve the crankcases slightly so that the bigger diameter liners will fit inside. I'd just ordered a new Dremel as my old Draper version was getting a bit tired. That thing has been amazing and I've had it almost twenty years — it's done lots of porting and polishing. Anyway, i was in the process of grinding out some of the casing when the Draper tool finally gave up and spat chunks of plastic out the side. The Dremel came just in time!

If you're wondering about the quality of the deburring tools, sandpaper barrels etc., the Dremel ones are superb! I've always bought the cheaper versions and they wear out in seconds, The Dremel ones are worth the extra cost. 

But on with the job. 

I found it easier to slip the cylinders over the studs, turn the case upside down and mark where the liners were touching. Then remove the cylinders and start grinding. Bit by bit, they went lower and lower.